Instructions
Things You'll Need:
- Screwdriver
- Hex-driver
-
1
Disconnect power to the range, then pull the range away from the wall so the rear is accessible.
-
2
Remove the screws securing the main rear panel to the range, then remove the panel.
-
3
Draw a basic diagram of the wire configuration to the old terminal block before removing the wires.
-
4
Remove the wires from the old terminal block by removing the screws on each terminal, then pulling the wire off of the screw post.
-
5
Remove the old terminal block by removing the mounting screws, or mounting bolts, depending on model.
-
6
Align the new terminal block, then secure with the mounting screws or bolts.
-
7
Reconnect the wires to the screws, then reconnect the cables according to your diagram.
-
8
Replace the rear panel of the range, securing it with the screws that were removed.
-
9
Push the range back against the wall, then restore power to complete the installation of the new terminal block.