-
Lay the red and black cable out along the desired routing from the battery to the terminal block. Cut the cable to length--be careful to not cut it too short.
-
2
Strip the last 1/2 inch of insulation off of all four ends. Insert each end into a terminal lug and place the lug into the lug crimper. Strike the crimper with the hammer until the lug is thoroughly crimped tight.
-
3
Connect the wires to the battery posts--red to positive, black to negative--and their respective terminal blocks. Install the lockwashers and tighten the battery bolts and terminal block nuts down firmly.
Products List
ElectroMagnetic Compatibility: With the proliferation of electronic systems in every aspect of our daily lives, there inevitably comes the problem of compatibility. Listening to the news on AM radio while ...
In order to provide better service and reduce cost for our customer, We are making a special customer Cservice centers.All of enclosures can be customized to meet the exact requirements of a customer's...